1
Flush
Add Clorox Spa System Cleanse to remove debris from the plumbing. Run the pump to ensure it reaches all sections of the lines.
2
Drain
Turn off the power, then drain water from the spa using a hose attached to the spigot at the bottom of your tub.
3
Clean Filter
Remove and clean the filter as you normally would. Replace it if it is worn or torn.
4
Clean Surfaces
Wipe down tub surfaces, headrests and tub exterior or enclosure.
5
Refill
Add fresh water through the filter reservoir to remove any debris before it enters the system. Make sure power is turned off and close all spa drains.
6
Test & Adjust
Follow the usual testing routine to balance water and get sanitizer levels in the accepted range.
